Dynamic Wind Loading and Uplift Testing
We offer dynamic wind loading and wind uplift tests for walls (including external wall insulation (EWI) systems), façades, roofing membrane and insulation, rainscreens, pitched and flat roofing, solar panels and veture kits.
Video Clip from the Test Rig
In the clip below, aluminium standing seam roofing is tested under simulated wind suction. The section of roof being tested ripples a little before a classic negative pressure failure at 5.2kpa. We recommend watching this clip with the sound turned up.
The indoor electrical fan systems enable products or systems to be dynamically loaded under negative/positive pressures using air controlled at various speeds. The products/systems can be tested to:
Roofs Standards
- EAD 030350-00-0402 (former ETAG 005) – Liquid Applied Waterproofing Kits
- EAD 030351-00-0402 (former ETAG 006) – Systems of Mechanically Fastened Flexible Roof Waterproofing Membranes
- BS EN 16002:2018 - Flexible sheets for waterproofing. Determination of the resistance to wind load of mechanically fastened flexible sheets for roof waterproofing
- M.O.A.T. 64,65,66 – UEAtc Technical Guide for the assessment of roof waterproofing systems
- BS EN 5534 – Slating and Tiling for Pitched Roofs and Vertical Cladding
- Customised programs
Walls Standards
- EAD 040914-00-0404 - Veture Kits
- EAD 090019-00-0404 - Kits for external wall cladding of mineral boards with renderings applied in situ
- EAD 090020-00-0404 - Kits for external wall claddings made of agglomerated stone
- EAD 090058-00-0404 - Ventilated external wall cladding kit
- EAD 040083-00-0404 - ETICS 1 with Rendering
- EAD 040287-00-0404 - ETICS 2 with Panels
- EAD 090062-00-0404 - Cladding Kits
- CWCT Standards – Wind Serviceability, Wind Safety, Water Penetration and Impact Tests
- BS EN 5534 – Slating and Tiling for Pitched Roofs and Vertical Cladding
- BS EN 13830 – Curtain Walling
- Customised programs
Wind Loading Test Rig for Walls
- The capability to apply negative and positive wind gusts greater than any UK requirement
- A 6.2m high by 3.6m wide chamber which facilitates two-storey height testing with a horizontal movement joint
- Simulation of wind-driven rain via a purpose-built water spray system
- A programmable control mechanism for standard or customised programs
- The ability to measure multiple displacement readings on the system
Wind Uplift Test Rig for Roofs
- The capacity to test samples up to 4m X 3m (maximum)
- The adjustability to house various roofing systems and depths of construction
- Windows to view tests in progress
- Climate controlled conditions
Benefits
- Confidential product and system development and innovation
- Data towards CPC agrement
- Data towards CWCT Certification
- Product and system verification
- Data against product and system failures
- Project specific data
- Supportive test data on file
- Flexible testing processes
- Controllable loading sequence and environment
- Technical team can assist with the design of customised testing programs
- In-house experienced installers available
- We also provide accredited tests such as pull through of fixings, flexural strength, hygrothermal resistance, material properties of installation, hard and soft body impact resistance; these are often prerequisites in standards which require dynamic wind loading tests